Perfect Concrete Floor

Because of weak subgrade compacting, most concrete floors and cement slabs break. The majority of concrete contractors put in the time and effort to do so. However, it wouldn’t hurt to double-check with one of those other guys, as compacting the subgrade is one of your concerns when looking for a cement contractor. Lifts of no more than six inches should be compacted into your subgrade. A contractor should compact every six inches of dirt thrown into a field. Visit our website to get   more about it

If you’re building a house in a wet or swampy place, you’ll want to spend a little extra money on planning. Perforated tile should be mounted under the cement floor via the footings by your cement contractor. These will flow into pea gravel-filled drainage pits. Then cover the concrete floor’s subgrade with four inches of pea gravel. The water would not be able to make its way through the basement floor as a result of this. If you use too much water in the cement mix, your floor will break. Concrete should have a clear slump when it is poured. The strength of the concrete at the end of the chute is like this. The concrete should be slightly rigid but workable. What you don’t want to see is concrete that looks like soup coming out of the chute. The more water in the mix, the more shrinkage and cracking the concrete will experience. When excess water evaporates from the poured slab, it can shrink as much as a half inch in a hundred feet. The concrete’s strength would be significantly reduced if there is too much water in it.

If the concrete dries too soon, it will break. Spray a small mist of water on the top of your cement floor as it dries to prevent it from drying too fast. Another option is to cover the cement slab with plastic or a light tarp to avoid rapid drying. If the basement floor is being poured with the existing floor in place, it will most likely dry without issue. Have your contractor mount control joints in your concrete floor while it’s either green or while it’s being installed. Every concrete contractor has seen a floor crack now and then. Cracks are often inevitable, which is why control joints are so critical. The control joint relieves tension in the cement and prevents cracking in the floor finish.